The idle sensor 2110 is an electrically controlled valve that regulates the amount of air bypassing the throttle, on cars with fuel injection system. This leads to the fact that the revolutions of the idle of the engine change as necessary. The computer of a car that controls this function receives information from the sensor and determines the amount of air that must be passed through it, bypassing the throttle.
Coaling sensor breakdown can lead to a reduction in the speed of idle or a complete stop of the engine. If your car has similar symptoms, then do not rush to the store for buying. It is possible that it can still be reanimated.
Carbon deposits can accumulate in the sensor and lead to a malfunction. Therefore, it must be cleaned regularly. It is advisable to clean the idle sensor, even if there are no obvious problems in order to prevent the dirty dirt. In this article we will consider how to clean the idle speed sensor VAZ 2110.
How to clean the idle sensor.
Drown out the car engine and wait until the engine cools down before starting.
Find the idle sensor under the hood. It is located in the upper part of the throttle case. The sensor has the shape of a barrel and is attached to the throttle of two screws.
Unscrew the idle sensor. Disconnect the wires going to the valve to remove the sensor.
Clean the valve with gas so that gasoline enters the valve spring. The idle sensor is a walking mechanism and the valve moves on the gear rod. It is dirt on the rod that prevents the valve to move.
Dry the sensor and blow it with compressed air.
Make sure the valve moves easily.
The installation of the idle sensor, make in the reverse order.
So, we were once again convinced that the exact diagnosis is the key to the successful repair of your car.