Replacing the rear racks of the VAZ 2110, the rear springs, does not require special tools and takes no more than an hour of work. In this article, we will take a step by step to replace the rear racks of the VAZ 2110, and at the same time the rear springs of the VAZ 2110, t. To. This is the same work.
We begin the work with the removal of trunk sheathing, in the area of the wheel arch. This is necessary to get to the top mount of the rear shock absorber.
Next, unscrew the nut of the upper mount with a capacity. So that the stem does not turn, hold it with an ore key at 6.
The upper mount was released, now we proceed to the lower mount. To do this, hang out and remove the rear wheel from the side of the replaced rack. Do not forget about the additional support for the car.
Unscrew and pull out the lower shock absorber bolt with a key.
Remove the rear rack along with the spring. Also remove the rubber spacer under the spring from the body.
In the upper part of the rod of the old shock absorber there is a spacer sleeve. Remove it and rearrange it on a new shock absorber. If you install a shock absorber without a sleeve, then it is likely that the shock absorber will break the seat on the wheel arch. It is also recommended to lubricate the stroke stroke with silicone to extend the service life of the rear rack.
Next, after replacing the necessary details, we proceed to the assembly. So that the upper gasket does not fall out, fix it on the spring using tape or island.
Install the rear rack, along with the spring, in the elongated position and twist (do not tighten) the lower bolt of the fastening of the rack.
Now we put it under a healthy beam, from the side of the changing rack, support and lower the car simultaneously directing the stroke of the rack into the opening of the upper seat on the shelter. After the rod climbed from the trunk side, we tighten the upper nut of the rack mount.
Lower mount bolt and top nut is tightened when the car is on wheels.